Difference between revisions of "Motion Capture Demo"
esse quam videri
Line 19: | Line 19: | ||
** in either case, the data can be massaged later in the pipeline (better to have more) | ** in either case, the data can be massaged later in the pipeline (better to have more) | ||
* Calibration L-seed - switch to calibration tab | * Calibration L-seed - switch to calibration tab | ||
− | **Turn on the cameras, put the L-device on the floor | + | **Turn on the cameras, put the L-device on the floor, connect to cameras |
+ | **"Run" the cameras for a couple seconds | ||
* Mask out | * Mask out | ||
+ | ** switch to 2d mode, for each camera mask out any extraneous areas using middle mouse button (wheel) | ||
+ | ** for each camera, use tools ==> camera settings, to asjust the threshold to approximately 300 | ||
+ | ** repeat masking | ||
* wand, floor, ROM | * wand, floor, ROM | ||
* Data output, capture | * Data output, capture |
Revision as of 16:10, 14 August 2008
++Overview
- Motion Analysis hardware
- optical motion capture
- 10 Hawk cameras
- EVarts 5.04 software
++Uses of Character Animation, pipeline overview
- file formats
- Autodesk MotionBuilder 7.5
- marker sets
- TGEA
++Motion Capture Production (EVarts 5.04)
- Load a previous marker set (project (.prj) file)
- Marker set will be visible in post-process tab
- The number of markers will directly reflect the number of tracks in your track(.trc) file
- this will translate to points on the skeleton rig
- depending what your final destination for your Motion capture is, this may be dictate from the model being animated (if it is already created or not)
- in either case, the data can be massaged later in the pipeline (better to have more)
- Calibration L-seed - switch to calibration tab
- Turn on the cameras, put the L-device on the floor, connect to cameras
- "Run" the cameras for a couple seconds
- Mask out
- switch to 2d mode, for each camera mask out any extraneous areas using middle mouse button (wheel)
- for each camera, use tools ==> camera settings, to asjust the threshold to approximately 300
- repeat masking
- wand, floor, ROM
- Data output, capture
- EVarts 5.04 Post production
++Autodesk MotionBuilder 7.5
- inputting TRC data
- cleaning up TRC data
- animation
- Output formats